Cha Cha in the Pumpkin Patch Bracelet

Supplies

Chain nose pliers
Round nose pliers
Wire cutters
7 inches of chain 30131788 (the one with figure 8 links between 6mm hoops)
1 medium lobster claw clasp

 

Directions

On one end of the chain, open the last figure 8 link and attach the lobster claw clasp. Close the link.
Starting from the next 6mm hoop, attach a pumpkin and leaf:

Pumpkin:
30116910 shorty mtn jade peach 12mm
6 green resin bell flowers
6 resin leaves
green 20 gauge wire

 

Helpful hint: Coat the round nose and chain nose pliers with 30135201 Tool Magic to prevent the green color from scratching off the wire when you do your wraps.

 

Take 4 inches of the wire and coil one end tightly about 3 times. Slip on the peach bead and then the bell flower, wire wrap to the hoop but leave about 1 inch of wire to coil up into a tendril.

Take 3 inches of wire and coil one end tightly about 3 times. Slip on a resin leaf and wire wrap to the same hoop as the pumpkin.

On the next 6mm hoop, attach a witch:

 

Witch:
2 inch head pins
5 black resin fluted flower
30099829 donut bead 8mm black ab
30097743 pearl 6mm lt green
5 black small resin bell flowers
30060879 plastic bicone 3mm black

 

On a head pin, slip on a fluted flower, an 8mm donut, a green pearl, a small bell flower and a 3mm bicone. Wire wrap to the hoop.

On the next 6mm hoop, attach a ghost:

 

Ghost:
2 inch head pins
5 white medium resin bell flower

30097749 pearl 6mm white

 

On a head pin, slip on the white bell flower and then a white pearl. Wire wrap to the hoop.

 

Repeat this sequence of characters until you reach the second to the last 6mm hoop. The last hoop is to remain empty so that the lobster claw can attach to close the bracelet.

 

 

2012 Ben Franklin Crafts, Inc.

 

  printer-friendly version

 

Back Home   Search Category   Search Name   All Projects List