Halloween Scrapbook Page

 

 

Supplies

FISKARS ShapeBoss

FISKARS ShapeBoss™ Stencil Set - Celebrations, Alpha Blocks

FISKARS Photo Trimmer

FISKARS Photo Stickers

FISKARS Scissors

12" x 12" Patterned Background Paper

Cardstocks - sage, rust, tan

Decorating chalk - sage

Dress It Up embellishments - ghosts, bat

Craft fibers - fuzzy sage

Black writing pen

Craft glue

Sticky foam pop dots

Project courtesy of Fiskars
Design by Jennifer Dammann

Directions

Insert rust cardstock between Celebrations stencils on ShapeBoss tray. Emboss (3) pumpkin shapes (just round part of pumpkin, not the stem). Remove and trim all pumpkin shapes using scissors. Repeat with sage paper for stems.

Cut 3 pieces of tan cardstock to measure 2" square. Adhere pumpkin and stem to center of each square using photo stickers. Adhere squares to sage cardstock. Tear sage cardstock around cream squares, leaving approximately a " torn border.

Insert cream cardstock between Alpha Blocks stencils on ShapeBoss tray. Emboss "BOO" onto cardstock, lining up the word as you go. Remove one stencil from tray and use as chalking stencil. Lightly chalk all letters in word "BOO" with sage chalk. Trim cardstock around word "BOO". Adhere this layer to rust cardstock. Trim around tan cardstock piece, leaving approximately a " border. Adhere both layers to sage cardstock. Tear sage cardstock around rust layer, leaving approximately a " torn border.

Cut a piece of tan cardstock to measure 2" x 2". Adhere this piece to sage cardstock. Tear sage cardstock around square, leaving approximately a " torn border. Journal message about photo onto this piece using black writing pen.

Trim photo to desired size. Adhere to tan cardstock. Trim cardstock around photo, leaving approximately a " border around photo. Adhere both layers to sage cardstock. Tear sage cardstock around tan piece, leaving approximately a " torn border. Adhere all layers to rust cardstock. Trim rust cardstock around torn border, leaving approximately a " border of rust around torn border.

Tear 3 squares from sage cardstock, measuring approximately 1" square each. Using craft glue, adhere one Halloween embellishment to each square diagonally.

Cut a piece of craft fibers to measure 48". Wrap around right edge of background paper and secure behind page using photo stickers or tape.

Using pop dots, adhere pumpkin layers over fibers. Adhere photo to page using pop dots. Adhere remaining pieces to page using photo stickers.

printer-friendly version

 

Back Home   Search Category   Search Name