Personalized Pendants


1 qty. Amate Studio Pendant Blank

Cardstock or printed paper sized to fit pendant blank

Glossy Accents #30014904

Embellishments: Rubberstamped designs, stickers, glitter, etc. 5/16”Meriken double stick tape #30013283




Sharp Scissors

Sharp Pin

Optional: Paper Punches (” circle # 30028718 fits smaller circle pendant, #30092441,30092442)


NOTE: The samples that used dandelion design rubber stamps were inked with Versafine black pigment ink and colored in with colored pencils on white cardstock. Max with cupcake design was cut out and adhered to a printed paper background. Circle pendant with cupcake is printed paper with glitter added. Rectangle pendant is washi paper.  



Carefully trace around your pendant blank to get a pattern for the insert. Trim as necessary and check the fit. TIP: Save this pattern for future projects.


Trace the pattern onto the wrong side of the paper with a pencil. Cut out and place inside the pendant blank to check the fit again. Trim as necessary.


Decorate your paper as desired or leave blank if you just want the printed design. If you are stamping a design, test any inks and/or coloring media to make sure that the colors will not run when it gets wet from the Glossy Accents.


Use a small piece of double stick tape on the back and adhere to the pendant blank. Place the pendant onto a flat surface. Carefully squeeze some Glossy Accents into the piece. NOTE: Remember not to shake the Glossy Accents bottle to avoid air bubbles.


You can add some fine glitter or small beads if you want. Continue filling the piece with Glossy Accents. Use the sharp in point to pop any air bubbles. Set aside to dry. The Glossy Accents will dry clear.



2008 Ben Franklin Crafts, Inc.


  printer-friendly version


Back Home   Search Category   Search Name   All Projects List