Polar Penguin

SUPPLIES:

2" X 4.5" Black Fun Foam
1.5" X 3" White Fun Foam
1.5" X 3" Yellow or Orange Fun Foam
1/2" X 1" Red Fun Foam
1/2" X 1/2" Blue Fun Foam
2 - 5mm moving eyes
Low Temp Glue Gun 
Optional:
     For a Pin - 1 pin back
     Ornament - 4" of 1/8" ribbon

DIRECTIONS:  

Trace and cut out of fun foam the pieces according to the pattern.  

Center the white tummy piece onto the black body piece, aligning the bottom edges. Glue together. Place the two feet at the bottom of the penguin and glue in place. Place the wings on either side of  the penguin body just below the neck. Glue in place.

Glue the eyes to the face. Glue the beak below the eyes and glue the heart cheeks on either side of the beak. Glue the bowtie on the neck.

To use as a pin, glue a pin back to the back of the penguin. For an ornament, tie the ends of the 1/8" ribbon together, glue to top back of penguin.

printer-friendly version

Back Home   Search Category   Search Name