Sparkling Snowflake Gift Tag
This project courtesy of Fiskars®.

 

Supplies

Fiskars® Parchamoré Crafting System Starter Set

Fiskars® Parchamoré Stencil Set Snowflakes

Fiskars® Parchamoré Parchment Paper Pack

Fiskars® ShapeTemplate™ Tool - Tags-1 w/Seagull Border

Fiskars® ShapeCutter™ Tool

Fiskars® Self-Healing Craft Mat 12˝"x12˝"

Fiskars® Sunflower Paper Edgers

Blue and silver pearl card stock

White fiber

"To" and "From" rubber stamps

Clear embossing ink

White embossing powder

Embossing heat tool

Mini Glue Dots®

Terrifically Tacky Tape™ – 1”

Wax paper, cello tape, straight pin


          

Directions

Using ShapeCutter ™ and jumbo tag template cut two parchment, one silver pearl and one blue pearl card stock tags.

To create snowflake tag, tape parchment tag onto foam pad with notched side placed to the right. Rub with wax paper.

Place stencil #1 right side down onto foam pad with “Fiskars” to the right.

Outline left snowflake with fine tip. Emboss diamond shapes with large tip. Remove stencil.

Place stencil #2 right side down onto foam pad. Outline circle motifs of the same snowflake with fine tip. Emboss with large tip. Remove stencil.

Place stencil #3 right side down onto foam pad. Outline center of snowflake with fine tip. Pierce with piercing tip following template. Pierce three freehand holes in each point of snowflake center. Remove stencil, tape & parchment. Note: we have been working on the back of the piece for all of these steps.

Apply 1” wide tape to blue or silver pearl card stock. Punch 7 stars from taped area.

Using a straight pin, remove liner from punched star. Working on the front side of piece adhere stars to snowflake. Refer to photo for placement.

Stamp and emboss with white powder “To” and “From” on front of tag.

Adhere parchment tag to blue or silver card stock tag with punched star adhesive or mini glue dots, hide behind punch card stock stars. Trim card stock tag with sunflower edgers.

Punch star through both layers at notched end of tag.

Cut 18” length of white fiber; fold in half twice. Insert fiber through punched star from back to front; pull tails through loop.

printer-friendly version

 

Back Home   Search Category   Search Name