Stars Scrapbook Page
This project is courtesy of Fiskars®.



Fiskars® ShapeBoss Embossing System Starter Set

Fiskars® Embossing Stencil Set - Basic

Fiskars® Embossing Stencil Set - Alpha Block Letters

Fiskars® ShapeCutter Tool

Fiskars® ShapeTemplate Tool - Tags-1 with Seagull Border

Fiskars® Self-Healing Craft Mat 12˝" x 12˝"

Fiskars®  Hand Punch - 1/8" Circle

Cardstocks - 12" x 12" periwinkle, 8˝" x 11" sheet of white, butter yellow

Twistel - yellow

Yellow embroidery thread

Eyelets - (10) blue, (2) white, (2) yellow

Eyelet applicator tool


Double-sided foam tape

Decorating Chalk - blue

Black & White photo

Sticky foam pop dots

Black pen


Using photo stickers, mount photo to white cardstock. Trim white cardstock around photo leaving a 1/16" border.

Cut a piece of yellow cardstock to measure 7" x 9". Also cut a piece of white cardstock to measure 8˝" x 4˝". Adhere white piece to upper right corner of periwinkle paper, and yellow piece to lower left corner of periwinkle paper.

Cut five pieces of white cardstock to measure 2" x 2". Insert one square between Alpha Block Stencils on ShapeBoss tray. On each letter, emboss one letter in the word "WAGON". Using hand punch, punch a hole in the center of both top and bottom edges of each square. Insert eyelet into squares. Flip over onto craft mat. Insert eyelet tool into backside of eyelet. Gently tap 2 - 3 times onto tool, or until backside of eyelet begins to curl over. Remove tool, then tap directly onto eyelet to finish. Repeat for all eyelets.

Cut a piece of Twistel to measure approximately 20". Tie a knot in one end. Begin threading other end through pieces, making sure the longest portion is behind letter blocks. After this has been threaded through each letter, tie knot in other end and trim both ends. Apply pop dots to backside of each letter.

Replace alphabet stencil with Basic Shapes stencil, then emboss varying sizes of yellow and blue stars. Trim around embossed shapes with scissors. Apply pop dots to just a few of the stars.

Using ShapeCutter with Tags ShapeTemplate and craft mat, cut 2 round tag shapes from white cardstock. Punch hole in tag at curved end. Apply yellow eyelet to each hole according to directions above. Using black writing pen, journal child's name on one tag, and date of photo on other tag.

printer-friendly version


Back Home   Search Category   Search Name